BAYWATCH

> HOW TO FABRICATE A PAIR OF INNER FENDERS TO COMPLETE OUR SMOOTHED ENGINE BAY

- CHAD ATKINSON

FOLLOWING on from last month’s column on how to fabricate a flat firewall, we now turn our attention to fabricating a pair of inner fenders to complete a silky-smooth engine bay. Again, this isn’t so much a ‘how to’ guide as it is a little insight into the thought process and metal fabrication required for a job like this.

STEP 01

The rod frames we fabricated for the firewall design last issue now come in handy as a guide to see where the new panels will sit. Some scrap 0.6mm steel sheet serves as a template to get a correct line on the bottom edge. Decent card coupled with masking tape also comes in handy for this sort of work.

STEP 02

A much-needed visit from the blaster sees things taken back to bare metal, making the bay much easier and a whole lot nicer to work on. Once blasted, everything is coated in Oxytech’s Easy Phos to prevent surface rust.

STEP 03