A: If you are having trouble ejecting spent brass, that is a mechanical problem with the rifle, not a problem with the ammunition. However, if you are having trouble extracting cases (sticky extraction) from the chamber, then you are probably experiencing high pressure. My maximum load for the 6.5 RPM using the 140-grain Nosler Partition bullet was 66.0 grains of Alliant Reloder 25 powder. This load was working fine in my rifle, as extraction was easy (or normal), and neither were there any signs of excess pressure.
この記事は Handloader の October - November 2020 版に掲載されています。
7 日間の Magzter GOLD 無料トライアルを開始して、何千もの厳選されたプレミアム ストーリー、8,500 以上の雑誌や新聞にアクセスしてください。
すでに購読者です ? サインイン
この記事は Handloader の October - November 2020 版に掲載されています。
7 日間の Magzter GOLD 無料トライアルを開始して、何千もの厳選されたプレミアム ストーリー、8,500 以上の雑誌や新聞にアクセスしてください。
すでに購読者です? サインイン
OEHLER's New System 89 Chronograph
Measuring Bullet Performance Downrange
The Problem with Low Pressure Loads
Bullets & Brass
Measurements for Rifle Handloading
Handy Techniques for Accurate Ammunition
THE BRASS RING
In Range
Semi-custom Bullet Moulds
Mike's Shoot in' Shack
REVISITING THE 6.5 -06 A-SQUARE
Loading New Bullets and Powders
Cimarron Stainless Frontier .45 Colt
From the Hip
9x18mm Makarov
Cartridge Board
Alliant 20/28
Propellant Profiles
.224 Clark
Wildcat Cartridges