Real-Time TEMPERATURE And HUMIDITY MONITORING SYSTEM Using TFT Display

Real-time environmental monitoring is increasingly important in agriculture, industrial automation, smart homes, and healthcare. The real-time data monitoring system measures and displays ambient temperature and humidity on a TFT display, along with the current time, using an Arduino microcontroller.

- ASHUTOSH M. BHATT

The system combines a DHT (digital humidity and temperature) sensor for environmental readings with an RTC module (DS1307) for timekeeping. Data and time are continuously displayed on the TFT screen with multicoloured graphics and a user-friendly interface. The Arduino reads sensor values and time data at regular intervals, updating the display every few seconds. Fig. 1 shows the prototype with a snapshot of the TFT display.

This compact, cost-effective, and accurate system is well-suited for smart homes, laboratories, greenhouses, and educational use. It also offers scope for expansion into data logging or wireless transmission for IoT-based applications. Table 1 lists the complete Bill of Materials.

Circuit and working

Fig. 2 shows the circuit diagram of the real-time data monitoring system using a TFT display. It is built around an Arduino Nano board (MOD1), DHT11 sensor (S1), RTC module (MOD2), TFT display (MOD3), and a few other components.

The DHT11 sensor module has three pins: Vcc, GND, and Out. The Vcc pin is connected to the 5V output of the Arduino board, the GND pin is connected to the common ground, and the output pin is connected to the Arduino's digital pin D2. A 10k pull-up resistor is connected between the output pin and Vcc, as recommended in the DHT sensor datasheet.

The RTC module has four pins: Vcc, GND, SDA, and SCL. Here, the Vcc pin is connected to 5V from the Arduino, while the SDA and SCL pins are connected to Arduino pins A4 (SDA) and A5 (SCL), respectively.

The TFT LCD module has nine interfacing pins, which are connected to the Arduino Nano board as shown in Table 2.